Microfoons Pre-amps Dynamics Tijdelijke Antelope specials

 

Converters Monitoring Overig Tijdelijke Rupert Neve Designs specials
Black-November-Actie: Koop of jaarhuur voor minimaal € 1.999 en ontvang een gratis Warm Audio WA87 ter waarde van € 537
Overstock (nieuw) Mooie retouren / B-stock Korte huur Jaarhuur

TritonAudio FetHead

Prijs bij jaarhuur: € 68,97

Prijs bij directe koop: Excl. BTW: € 54,99 Incl. BTW: € 66,54

Jaarhuur

Prijs bij jaarhuur: € 68,97

Prijs bij directe koop: Excl. BTW: € 54,99 Incl. BTW: € 66,54

 Incl. BTW

Korte beschrijving

FetHead is a low-noise, high quality, in-line microphone preamplifier.

Prijs op aanvraag
TritonAudio FetHead


Details

FetHead

Boost your microphone

  • For Ribbon and dynamic microphones
  • Ultra low noise Class A JFet amplifier
  • 27dB's of clean gain
  • Allows your mic to perform under "no-load" condition
  • Easy install - 2 clicks and done
  • Lowers the noise floor of your recordings
  • Shielded Enclosure
  • 4 Matched JFets

Boost your microphone

FetHead is a low-noise, high quality, in-line microphone preamplifier. It provides improved sound for Ribbon and Dynamic microphones. The electronics are housed in a robust metal chassis with a balanced 3-pole female XLR input and a balanced 3-pole male XLR output, rugged enough for use at home, in the studio or on tour.

 

Which microphones benefit

In short, we noticed an improvement on all tested microphones. A Shure SM57 for instance, sounds more responsive over a broader frequency range. When mated with a high-end dynamic microphone like a Sennheiser MD441, or Shure SM7 FetHead really shines. Ribbon microphones benefit greatly too because of a much better impedance match, which lessens the load on the microphone, giving it better transient response characteristics. FetHeads high quality, low noise signal amplification also extends the usable range of a ribbon microphone, making it more suitable for recording softer passages.

 

Protects the microphone

Some ribbon microphones do not tolerate phantom power. FetHead's circuit uses 48v phantom power but shields it from the microphone, so the microphone is protected.

  • Ultra low noise Class A JFet amplifier
  • 27dB amplification (@3 KOhm load)
  • 4 matched jFets
  • Z-in 22KOhm
  • 24-48V Phantom Power
  • For Ribbon & Dynamic microphones